Fluke Digital Multimeter 80 Series V Manuel d'utilisateur télécharger pdf (Page 21)

Digital Multimeter

Required Equipment

MIN MAX

RANGE

REL

Hz %

AutoHOLD

Peak MIN MAX

4½ DIGITS

1 Second

OFF

COM

400mA

FUSED

10A MAX

FUSED

TRUE RMS MULTIMETER

LOLO

MIN MAX

RANGE

REL

Hz %

AutoHOLD

Peak MIN MAX

4½ DIGITS

1 Second

OFF

COM

400mA

FUSED

10A MAX

FUSED

TRUE RMS MULTIMETER

LOLO

Good F2 fuse: 00.0 Ω to

00.5 Ω

Good F1 fuse: 0.995 kΩ to

1.005 kΩ

Replace fuse: OL

Touch top half

of input contacts

aom5f.eps

Figure 3. Testing the Current Input Fuses

Replacing the Fuses

To replace the fuse(s), perform the following procedure.

1. To open the Meter, refer to “Opening the Meter Case”. See Figure 1.

2. Grasp the fuse in the center with needle nose pliers. Pull straight up on the fuse to

remove it from the fuse clips.

3. Install ONLY specified replacement fuses with the amperage, voltage, and speed

ratings shown in Table 17.

4. To close the Meter, refer to “Reassembling the Meter Case”.

Required Equipment

Required equipment for the performance tests is listed in Table 13. If the recommended

models are not available, equipment with equivalent specifications may be used.

XW Warning

• To avoid shock or injury, do not perform the verification

tests or calibration adjustment procedures described in this

manual unless you are qualified to do so.

• Repairs or servicing should be performed only by qualified

personnel.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Fluke Digital Multimeter 80 Series V Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Fluke Digital Multimeter 80 Series V