Fluke 922 Manuel d'utilisateur télécharger pdf (Page 28)

922

Users Manual

Cleaning

Clean only with soap and water. Remove any residue afterwards.

Periodically wipe the case with a damp cloth and mild detergent.

Do not use abrasives or solvents.

Replacing the Batteries

When the low battery symbol appears (B) the meter will not save samples and “bAtt”

appears on the display when I is pressed.

The Meter uses four AA batteries (supplied). To replace the batteries, do the following (see

Figure 5):

1. Turn off the Meter.

2. Remove the holster.

3. Place the Meter face down on a nonabrasive surface and loosen the battery door

screw with a Phillips screwdriver.

4. Lift the battery access door away from the Meter.

5. Replace the batteries as shown in Figure 5. Observe the battery polarity shown in the

battery compartment.

6. Secure the battery access door back in position with the screw.

7. Reinstall the Holster.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

Pas de commentaire

Fluke 922 Manuel d'utilisateur Page 28