Fluke HART SCIENTIFIC 1502A Manuel d'utilisateur télécharger pdf (Page 9)

Before initial use, or after transport, or after storage in humid or semi-humid

environments, or anytime the instrument has not been energized for more than

10 days, the instrument needs to be energized for a "dry-out" period of 2 hours

before it can be assumed to meet all of the safety requirements of the IEC

1010-1. If the product is wet or has been in a wet environment, take necessary

measures to remove moisture prior to applying power such as storage in a low

humidity temperature chamber operating at 50°C for 4 hours or more.

Follow all safety guidelines listed in this user's guide.

Calibration Equipment should only be used by Trained Personnel.

To avoid possible burn hazards, follow these guidelines.

This instrument can measure extreme temperatures. Precautions must be taken

to prevent personal injury or damage to objects. Probes may be extremely hot

or cold. Cautiously handle probes to prevent personal injury. Carefully place

probes on a heat/cold resistant surface or rack until they reach room

temperature.

1.2.2

Cautions

To avoid possible damage to the instrument, follow these guidelines.

DO NOT change the values of the calibration constants from the factory set

values unless you are recalibrating the instrument. The correct setting of these

parameters is important to the safety and proper operation of the instrument.

Allow sufficient air circulation by leaving at least 3 inches of space between the

thermometer and nearby objects.

For CE compliance and for performance, use only the AC adapter shipped with

the instrument. If the AC adapter needs to be replaced, contact an Authorized

Service Center.

This instrument and thermometer probes are sensitive and can be easily dam

aged. Always handle these devices with care. DO NOT allow them to be

dropped, struck, stressed, or overheated.

Probes are fragile instruments which can be damaged by mechanical shock,

over-heating, and absorption of moisture or fluids in the wires or hub. Damage

may not be visibly apparent but nevertheless can cause drift, instability, and

loss of accuracy. Observe the following precautions:

DO NOT allow probes to be dropped, struck, bent, or stressed.

DO NOT overheat probes beyond their recommended temperature range.

DO NOT allow any part of the probe other than the sheath to be immersed in

fluid.

DO NOT allow the probe hub or wires to be exposed to excessive

temperatures.

1 Before You Start

Safety Information

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Pas de commentaire

Fluke HART SCIENTIFIC 1502A Manuel d'utilisateur Page 9