Fluke Speaker Rev. 4 Manuel d'utilisateur télécharger pdf (Page 30)

701/702

Users Manual

Charging the Battery

wBefore you use the calibrator for the first time,

charge its battery pack for 2 hours. Due to safety

requirements, the battery must be charged outside

the calibrator.

Figure 8 shows how to remove the battery. Remove

the battery door and tap the calibrator with your hand

to get the battery out. Place the battery in the

charger and connect the charger to line power. The

charger automatically senses line voltage and

adjusts itself accordingly.

A discharged battery is fully charged in 2 hours or

less in fast-charge mode (steady indicator light on

the charger). Full charge is maintained after that time

in trickle-charge mode (blinking indicator light on the

charger). Switching between charging modes is

automatic. You can leave the battery pack on trickle

charge indefinitely without damage.

NOTE

When you remove a charged battery from

the charger, wait for the blinking indicator to

go off before you insert a discharged battery.

It takes about 2 seconds for the battery

charger to reset.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 117 118

Pas de commentaire

Fluke Speaker Rev. 4 Manuel d'utilisateur Page 30