Fluke Speaker Rev. 4 Manuel d'utilisateur télécharger pdf (Page 66)

701/702

Users Manual

and connect the calibrator to the circuit to be

tested. Figure 20 shows an example.

2. If you want to automatically stop ramping if a trip

condition is detected, connect a voltage trip

circuit to the V MEAS jacks or a continuity trip

circuit to the mA

Ω

RTD MEAS jacks. (Continuity

detection is not available when sourcing current.)

3. If necessary, press M for SOURCE mode.

4. Set the calibrator for the desired source value as

previously described.

5. If you want to ramp the output in % of scale, set

% of scale as described previously under

“Sourcing in Percent of Scale.”

Press the More Choices softkey.

Press the Ramp softkey. The display changes to

the following:

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 117 118

Pas de commentaire

Fluke Speaker Rev. 4 Manuel d'utilisateur Page 66