Fluke Speaker Rev. 4 Manuel d'utilisateur télécharger pdf (Page 36)

701/702

Users Manual

Auto Backlight Off is activated, the asymbol shows

at the top of the display. To automatically turn off the

backlight after a set time, proceed as follows:

1. Press s.

2. Press d to highlight Off following Auto

Backlight Off.

3. Press e or the Choices softkey.

4. Press u to highlight On, then press e.

5. To accept the timeout period shown on the

display, you can finish here. Press Done to exit

s mode and do not go on to step 6.

6. To change the timeout period, press d to

highlight the timeout period following Backlight

Timeout.

7. Press e or the Choices softkey.

8. Enter your choice of timeout period in minutes

(accepted range: 1 to 120 minutes).

9. Press the Done softkey.

10. Press the Done softkey or s to exit s

mode.

Personalizing the Calibrator

You can load your name or some another

alphanumeric identifier into the calibrator for display

at power-up and in saved results. Proceed as follows

to load an identifier:

1. Press s

2. Press Next Page twice.

3. Press d to move the cursor to the same line as

ID.

4. Press e or the Choices softkey. The

display appears as follows:

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 117 118

Pas de commentaire

Fluke Speaker Rev. 4 Manuel d'utilisateur Page 36