Fluke LinkRunner Spécifications télécharger pdf (Page 13)

LinkRunner AT 1000/2000 Network Auto-Tester

Users Manual

The Home Screen

ffy15.eps

Figure 2. The Home Screen

 Switch: Shows the advertised and actual link, PoE

measurements, nearest switch with its name, type, IP

address, port, slot, and VLAN information.

 Cable: When the cable is connected un-terminated or is

connected to a WireView

Office Locator, it shows cable

information or wire mapping information. This can also

be used to locate a cable with the optional IntelliTone

probe.

 The name of the tester profile. A profile contains the

tester configuration settings. The default name is

“Untitled”. The name shows an asterisk to the right of

the name if you have changed a setting on the tester

since you loaded or saved the profile.

 AutoTest: Use Autotest to Ping and connect to selected

targets. Up to 10 targets can be entered as a URL or IPv4/

IPv6 address along with the optional port number.

When no port is specified, a Ping is performed. When

the port is specified, a TCP SYN/ACK is performed. This is

also referred to as a TCP Connectivity test.

 Tools lets you manage files and settings.

 Link established indicator.

 Displays the link speed and duplex mode.



Shows the battery status. When the battery

charge is low, the icon blinks. Connect the AC

adapter to charge the battery and to make

sure the tester continues to operate.

Shows that the AC adapter is connected.

Shows that the USB interface is connected.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Pas de commentaire

Fluke LinkRunner Spécifications Page 13