Fluke Speaker Rev. 4 Manuel d'utilisateur télécharger pdf (Page 27)

Documenting Process Calibrator

Setting Up the Calibrator

Display

Figure 6 shows the features of a typical display. The

display shown is MEASURE mode. Near the top of

the display is “Source Off.” This is the area of the

display that shows what is happening in the other

mode (SOURCE or MEASURE). The other parts of

the display are as follows:

•

Status Bar: shows the time and date (if set in

Setup mode), and shows the status of Loop

Power, Battery Save, and Backlight Timeout; all

of which are set in Setup mode. The low battery

and backlight on annunciators also appear here.

•

Mode Indicator: Shows whether the calibrator is

in MEASURE or SOURCE mode. In split screen

MEASURE/SOURCE mode, there is a Mode

Indicator for each window.

•

Measured Value: Shows the measured value in

your choice of engineering units or percent of

scale.

•

Range Status: Shows whether Auto Range is on,

and what range is currently being used.

Setting Up the Calibrator

This section consists of general information that

should be read before you use the calibrator.

Using the Strap and Bail

After you unpack the calibrator, attach its carrying

strap as shown in Figure 7. You can adjust the strap

as necessary to hang the calibrator on any sturdy

support. Figure 4 also shows you how to prop open

the bail to stand the calibrator at a comfortable

viewing angle for benchtop use.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 117 118

Pas de commentaire

Fluke Speaker Rev. 4 Manuel d'utilisateur Page 27